Product Title
KUKA 00-166-354 Extension | DataCable 830mm Y-Con Plug | Heavy-Duty Industrial Ethernet Harness for KUKA Robot Controllers
Technical Summary
The KUKA 00-166-352 (830mm Version) is an extended-reach, high-speed data transmission cable designed for internal robotic networking. Featuring the specialized Y-Con (Yamaichi) RJ45 connector system, this 830mm harness provides the necessary length for complex cable management paths between the PC-Core and peripheral control modules in KUKA KR C4 and KR C5 cabinets.
Key Engineering Advantages
1. Precision 830mm Extended Length
The 830mm span is specifically engineered for:
-
Vertical Cabinet Routing: Reaching from the top-mounted PC-Core to bottom-tier I/O modules.
-
Service Loop Capability: Provides enough slack to allow for module maintenance without disconnecting the data bus.
-
Strain Relief: Prevents connector fatigue by allowing for natural bending radii within the controller.
2. Y-Con Connector Reliability
The Yamaichi Y-Con system is the industrial evolution of the RJ45. It features:
-
Vibration-Locking Clips: Ensures a fail-safe connection even when the robot controller is mounted on vibrating platforms.
-
Integrated Power Pins: Designed to support auxiliary power lines alongside high-speed data.
-
Enhanced Shielding: Protects against the high-frequency EMI generated by 6-axis servo drives.
3. Certified Signal Integrity
-
Low Attenuation: Despite the 830mm length, the cable maintains high-speed Cat5e/Cat6 performance levels.
-
Oil & Heat Resistant: The outer jacket is built to survive the high-temperature environment of a sealed industrial cabinet.
Technical Specifications
| Specification | Technical Data |
| KUKA Part ID | 00-166-354 (830mm Spec) |
| Connector A | Y-Con Industrial RJ45 (Metal Shielded) |
| Connector B | Industrial RJ45 (Metal Shielded) |
| Total Length | 830mm (0.83 Meters) |
| Data Rate | 100 Mbit/s – 1 Gbit/s (Industrial Ethernet) |
| Jacket Material | High-Flex PUR / Flame Retardant |
| Compatibility | KUKA KR C4, KR C4 Compact, KR C5 Controllers |
Diagnostic & Maintenance Use Cases
-
EtherCAT Bridge: Essential for linking the CCU (Cabinet Control Unit) to the SIB (Safety Interface Board).
-
Fault Prevention: Replace existing 300mm/600mm cables with this 830mm version if your cabinet layout requires a more flexible routing path to avoid electromagnetic interference sources.
-
SmartPAD Extension: Can be used as an internal bridge for SmartPAD connection ports.
Why Upgrade to our 830mm Harness?
Using the correct length is vital. A cable that is too short causes tension-related pin failure; a cable that is too long creates a “coil” that acts as an antenna for noise. The 830mm specification is the “Goldilocks” length for specific KUKA cabinet configurations, ensuring a clean, noise-free, and professional installation.
Reviews
There are no reviews yet.